Precautions for building GYTA53 outdoor fiber optic cable ducts:
(1) During the construction of GYTA53 optical cable pipeline, because the road surface is not wide enough, several units with weak electricity share the ditch and do not share the management. Therefore, each unit designs manholes and handhole wells that conform to its own line direction, and the load-bearing of the manhole cover must meet the requirements.
GYTA53 Outdoor Optical Fiber Cable
(2) All pipes do not use corrugated pipes, but use seven-hole plum blossom pipes with better quality, which is convenient for pipe penetration and development.
(3) Since there are many GYTA53 outdoor fiber optic cable pipes, generally weak current pipes are only buried on one side, and more pipelines should be designed to cross the street for ease of use.
(4) The plum blossom pipe should be covered with thickened galvanized steel pipe to make it can bear the pressure of the vehicle.
(5) For each man well and hand hole well, the auxiliary pipes should be buried out of the sidewalk, and buried on the side of the wall as much as possible, so as not to affect the appearance and to facilitate the installation of cables on the wall.
(6) Do not lay concrete in man wells and hand hole wells, so that there will not be too much water in the well.
(7) The junction box should be installed on the wall as much as possible. When it is impossible to install on the wall and is located on the ground, it is better to set it in the green belt, which is safer.
GYTA53 Outdoor Optical Fiber Cable
Through the introduction of ZR Fiber, I believe that everyone has some understanding of the precautions for the construction of GYTA53 outdoor fiber optic cable ducts. If you want to know more about ZR fiber jumper products, welcome customers to come and consult.
